Electric Nail Drill Repair
Bearings, armature and speed control restored on Dremel-style and professional handpieces. Unit is run under load for thirty minutes before return.
Drill handpieces, dust extractors and ventilation motors brought back to spec. We test every unit on our bench before it leaves the shop.
Nail Tech started in a one-bay shop in 2018 after the owner spent eight years maintaining industrial motors for a packaging plant. The same test procedures and parts standards apply to the smaller equipment salons rely on every day.
Most work comes from independent nail techs and small salons that cannot afford downtime on a single drill or extractor. Every unit is logged, tested under load, and returned with a one-page report.
When the tool stops, the chair stops. We keep the equipment that actually earns money in working order.
Bearings, armature and speed control restored on Dremel-style and professional handpieces. Unit is run under load for thirty minutes before return.
Motor brushes, impeller balance and HEPA filter housing cleaned and sealed. Airflow measured and recorded on the work order.
Exhaust fan motors, speed controllers and duct sensors replaced or rewired. System is flow-tested before it leaves the shop.
Ballast, timer board and LED array replacement on table-top and floor-standing units. Output measured with a UV meter.
Pressure switch, regulator and tank drain valve serviced on small salon compressors. Leak test and duty cycle recorded.
RPM verification, collet inspection and vibration check on high-speed handpieces. Certificate of calibration supplied with the unit.
One photo of a completed repair every day we are on the bench — the handpiece, the motor, the filter housing we returned that morning. Shot on the phone, posted before close.
Units that came through the shop this month. Most photos are taken on the bench before the unit is boxed.
Four details that determine whether a repair lasts or fails inside six months.
Every handpiece and motor is run under measured load for a minimum of thirty minutes before it leaves.
Common bearings, brushes and switches are on the shelf. No two-week wait for a $12 part.
You receive a printed sheet listing parts replaced, test readings and expected service interval.
We run a weekly loop through Chicago, Naperville, Schaumburg and Oak Brook. Same-week service on most jobs.
Drop the unit at the shop or schedule a pickup. Include the make and model and a short note on the symptom.
Text or email the make, model and what the unit is doing. If we cannot repair it we will say so before you bring it in.
(312) 555-0144 bench@nailtechrepair.com